Hi,
Was it also show "-bash: dahdi: command no found" when you typed "dahdi show channels" after "module load chan_dahdi.so"? Plwase send the log file (/var/loag/asterisk/full) to me. My Email: This email address is being protected from spambots. You need JavaScript enabled to view it.
Hi, yes show same error after that.
I also repeat the instruction from manual step by step. there are not errors until last command (dahdi show channels)
here some files
.# Autogenerated by /usr/sbin/dahdi_genconf on Wed Apr 13 09:48:21 2011
# If you edit this file and execute /usr/sbin/dahdi_genconf again,
# your manual changes will be LOST.
# Dahdi Configuration File
#
# This file is parsed by the Dahdi Configurator, dahdi_cfg
#
# Span 1: WCTDM/4 "Wildcard TDM400P REV E/F Board 5" (MASTER)
fxsks=1
echocanceller=mg2,1
# channel 2, WCTDM/4/1, no module.
# channel 3, WCTDM/4/2, no module.
# channel 4, WCTDM/4/3, no module.
Hi,
Please disable the last lines of /etc/asterisk/chan_dahdi.conf :
;# Flash Operator Panel will parse this file for dahdi trunk buttons
;# AMPLABEL will be used for the display labels on the buttons
;# %c Dahdi Channel number
;# %n Line number
;# %N Line number, but restart counter
;# Example:
;# ;AMPLABEL:Channel %c - Button %n
;# For Dahdi/* buttons use the following
;# (where x=number of buttons to dislpay)
;# ;AMPWILDCARDLABEL(x):MyLabel
[channels]
language=en
; include dahdi extensions defined in FreePBX
#include dahdi-channels.conf
#include chan_dahdi_additional.conf